Geodimeter 600 / Trimble 5600 18AH Battery Pack and Charger with 9-pin Serial Connector

GPAC Portable Power Solution Battery Pack

Efficient - Simple - Flexible - Fool Proof

Key Features:

Utilizing a 12 volt 18 amp hour Sealed Lead Acid Battery (SLA) enclosed within a 1000 denier, highly visible safety orange Ballistic Nylon case; the GPAC Portable Power Solution battery pack features 2 fused 20 amp outputs with Anderson Power Pole connectors and a built-in cable pouch that houses the output cable connectors, cables and accessories. The case is equipped with non-conductive heavy duty zippers and a soft grip carry strap.

Weighing in at just over 12 pounds the pack carries easy and delivers power to spare. The Geodimeter 600 / Trimble 5600's power consumption is rated at 14.4 watts. This pack will operate either unit for approximately 15 hours from a full charge.

The fused outputs and polarity protected Anderson Power Pole connectors insures that the equipment under power is well protected from short circuits and reverse polarity problems that can happen with power cables equipped with alligator clips.

This model includes a 2 meter wye cable with a 9-pin serial port connector at one end, the Hirose 4-pin connector at the opposite end and an Anderson Power Pole connector on the wye. The leg from the instrument to the data collector is 1 meter long. The leg from the instrument to the Anderson Power Pole connector is 2 meters long. You may specify any custom leg lengths to suit your application. Otherwise the standard wye cable will be shipped. Please allow 1-2 days additional for custom cable configurations.

The Portable Power Solutions Pack Includes:

• 1000d Ballistic Nylon Case with zippered cable and battery compartments
• 13.8 Volt 18 amp hour Sealed Lead Acid Battery
• 2 separate fused 13.8 volt 20 amp rated outputs
• 13.8 Volt Dual rate Automatic Charger / Maintainer
• 1 set of Anderson Power Poles to retrofit an existing power cable
• 2 meter wye power cable equipped with a Hirose 4-pin connector, 9-pin Serial Connector, and Anderson Power Pole connector
• Covered SAE 2-pin connector
• Accessories pack

Battery Charger Information

Battery charger accepts AC voltages from 90 volts to 264 volts at 45-65 cycles. It is equipped with a IEC 320 C14 appliance receptacle. The standard USA power cord for 110VAC operation is shown.